Assigning Ip Address Via "Wago Ethernet Settings - WAGO 750-363/0040-0000 Manual

100 Commissioning
Eine näh ere Anga be v on Jü rge n e rhal
8.3.3

Assigning IP Address via "WAGO Ethernet Settings"

Note Software Compatibility!
Refer to the version of the software specified in "Software Compatibility" in the
Technical Data.
This program is used to configure an IP address, to reset the fieldbus
coupler/controller parameters to the factory settings and to restore the Flash File
System in which the WBM pages of the fieldbus coupler/controller are stored.
"WAGO Ethernet Settings" can be used via the serial service interface or via the
ETHERNET interface.
For initial commissioning, however, the way via the serial service interface is
described here, because for access via the ETHERNET interface the currently
assigned IP address must already be known.
WAGO communication cables or WAGO radio-link adapters can be used for data
communication via the serial service interface.
Do not connect Communication Cable when energized!
To prevent damage to the service interface, do not connect or disconnect 750-
920 respectively 750-923 Communication Cable when energized! The fieldbus
coupler/controller must be de-energized!
Set the address selection switch to 0 for an IP assignment via software!
Set the address selection switch to "0" to disable the DIP switch.
Restart the fieldbus node after adjusting the address selection switch to apply the
configuration changes.
1. Using a WAGO Communication cable 750-920 respectively 750-923,
connect your PC with the service interface of the head station of the
fieldbus node.
Start "WAGO Ethernet Settings" program.
2.
3. Click on [Read] to read in and identify the connected fieldbus node.
4. Select the Network tab.
5. To assign a permanent address, select the option "Static configuration" in
the field Source.
Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
WAGO-I/O-SYSTEM 750