Preparing The Flash File System - WAGO 750-363/0040-0000 Manual

WAGO-I/O-SYSTEM 750
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
8.6

Preparing the Flash File System

The flash file system must be prepared in order to use the WBM of the fieldbus
coupler/controller of the fieldbus node to make all configurations.
The flash file system is already prepared when delivered.
However, if the flash file system has not been initialized on your fieldbus
coupler/controller or it has been destroyed due to an error, you first must initialize
it manually to access it.
Do not connect Communication Cable when energized!
To prevent damage to the service interface, do not connect or disconnect 750-
920 respectively 750-923 Communication Cable when energized! The fieldbus
coupler/controller must be de-energized!
Resetting erases data!
Note that resetting erases all data and configurations.
Only use this function when the flash file system has not been initialized yet or
has been destroyed due to an error.
1. Switch off the supply voltage of the fieldbus node.
2. Connect the communication cable 750-920 or 750-923 respectively the
Bluetooth
the fieldbus node and to your computer.
3. Switch on the supply voltage of the fieldbus node.
The head station is initialized. The head station determines the I/O module
configuration of the fieldbus node and creates a process image.
During start-up, the I/O LED (red) flashes.
If the I/O LED lights up green after a brief period, the fieldbus node is operational.
If an error occurs during start-up indicated by the I/O LED flashing red, evaluate
the error code and argument and resolve the error.
More information about LED signaling
The exact description for evaluating the LED signal displayed is available in the
section "Diagnostics" > ... > "LED Signaling".
Start the "WAGO Ethernet Settings" program.
4.
® Adapter 750-921 to the service interface of the head station of
Commissioning 107
Manual
Version 1.0.0