Connecting A Conductor To The Cage Clamp; Figure 41: Connecting A Conductor To A Cage Clamp - WAGO 750-363/0040-0000 Manual

84 Connect Devices
6.3

Connecting a Conductor to the CAGE CLAMP

The WAGO CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
1. For opening the CAGE CLAMP
above the connection.
2. Insert the conductor into the corresponding connection opening.
3. For closing the CAGE CLAMP
now clamped firmly in place.

Figure 41: Connecting a Conductor to a CAGE CLAMP

Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
connection is appropriate for solid, stranded and
®
® insert the actuating tool into the opening
simply remove the tool. The conductor is
®
®
WAGO-I/O-SYSTEM 750
®
® !
.
®