Table 115: Coupler/Controller Configuration - WAGO 750-363/0040-0000 Manual

186 Fieldbus Communication
Instance 1

Table 115: Coupler/Controller configuration (64

Attribute ID
5
6
7
8
9
10
11
12..26
40..43
45
46
47
Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
Acces NV Name
s
Get V ProcessStat
e
Get V DNS_i_
Trmnldia
Get V CnfLen.
AnalogOut
Get V CnfLen.
AnalogInp
Get V CnfLen.
DigitalOut
Get V CnfLen.
DigitalInp
Set NV Bk_Fault_
Reaction
Reserved for compatibility to DeviceNet
Reserved for compatibility to DeviceNet
Get V Bk_Led_Err
_Code
Get V Bk_Led_Err
_Arg
Get V Bk_Cfg_Dia
g_
Value
WAGO-I/O-SYSTEM 750
) – Instance 1
hex
Data type Description
USINT State of coupler/controller, error
mask:
Bit 0: Local bus error
Bit 3: Module diagnostics (0x08)
Bit 7: Fieldbus error (0x80)
UINT Module diagnostics:
Bit 0..7: Module number
Bit 8..14: Module channel
Bit 15: 0/1 Error, repair/arisen
UINT Number of I/O bits for the analog
output
UINT Number of I/O bits for the analog
input
UINT Number of I/O bits for the digital
output
UINT Number of I/O bits for the digital
input
USINT Fieldbus error reaction
0: stop local I/O cycles
1: set all output to 0
2: no error reaction
3: no error reaction
4: PFC task takes over control of
the outputs (apply to controllers)
UINT I/O LED error code
UINT I/O LED error argument
UINT I/O-Module diagnostics
(Module specific diagnostic
state)
Note: This attribute has to be
read out before attribute 6
(DNS_i_Trmnldia), because
during the reading of attribute 6
the diagnostic byte contains
the data of the next diagnostic
Default
value
0
0
-
-
-
-
1
0
0
0