Fieldbus Communication; Implemented Protocols; Communication Protocols; Ip (Internet Protocol) - WAGO 750-363/0040-0000 Manual

Fc ethernet/ip g4 eco xtr fieldbus coupler ethernet/ip; generation 4; eco; extreme for wago-i/o-system 750
Table of Contents

Advertisement

148 Fieldbus Communication

11
Fieldbus Communication
Fieldbus communication between master application and a WAGO fieldbus
coupler/controller based on the ETHERNET standard normally occurs via a
fieldbus-specific application protocol.
Depending on the application, this can be e.g., MODBUS TCP/UDP, EtherNet/IP,
BACnet/IP, KNXnet/IP, PROFINET, sercos or other.
In addition to the ETHERNET standard and the fieldbus-specific application
protocol, there are also other communications protocols important for reliable
communication and data transmission and other related protocols for configuring
and diagnosing the system implemented in the WAGO fieldbus coupler/controller
based on ETHERNET.
These protocols are explained in more detail in the other sections.
11.1

Implemented Protocols

11.1.1

Communication Protocols

11.1.1.1

IP (Internet Protocol)

The Internet protocol divides datagrams into segments and is responsible for
their transmission from one network subscriber to another. The stations involved
may be connected to the same network or to different physical networks which
are linked together by routers.
Routers are able to select various paths (network transmission paths) through
connected networks, and bypass congestion and individual network failures.
However, as individual paths may be selected which are shorter than other paths,
datagrams may overtake each other, causing the sequence of the data packets
to be incorrect.
Therefore, it is necessary to use a higher-level protocol, for example, TCP to
guarantee correct transmission.
IP Packet
In addition to the data units to be transported, the IP data packets contain a
range of address information and additional information in the packet header.

Table 69: IP Packet

IP Header
The most important information in the IP header is the IP address of the
transmitter and the receiver and the transport protocol used.
Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
IP Data
WAGO-I/O-SYSTEM 750

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents