Protocols; Table 49: Wbm Page „Protocols - WAGO 750-363/0040-0000 Manual

126 Configuring via the Web-Based Management System (WBM) WAGO-I/O-SYSTEM 750
9.11

Protocols

Use the "Protocols" WBM page to enable or disable ports for the services
available.
Close any ports and services that you do not need!
Unauthorized persons may gain access to your automation system through open
ports.
To reduce the risk of cyber attacks and, thus, enhance your cyber security, close
all ports and services in the control components (e.g., Port 6626 for WAGO
I/O-CHECK, Port 2455 for CODESYS 2 and Port 11740 for e!COCKPIT) not
required by your application.
Only open ports and services during commissioning and/or configuration.
Table 49: WBM page „Protocols"
Protocol Settings
Entry
FTP (Port 21)
SFTP (Port 22)
HTTP (Port __ )
HTTPS (Port 443)
SNTP (Port 123)
SNMP (Port 161, 162)
EtherNet/IP
(Port 44818 (TCP),
Port (2222 (UDP))
Service protocol
(Port 6626)
Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
Default Value Description
Enable "File Transfer Protocol"


Disable "File Transfer Protocol"

Enable "SSH File Transfer Protocol"


Disable "SSH File Transfer Protocol"

80 Port number setting for HTTP (1 ... 65535)
Disable "Hypertext Transfer Protocol"


Enable "Hypertext Transfer Protocol over SSL-

encrypted connection"
Disable "Hypertext Transfer Protocol over SSL-

encrypted connection"

Enable "File Transfer Protocol"

Operate WebVisu via HTTPS!
You can operate WebVisu via HTTPS protocol,
provided HTTPS is activated and you use a
WAGO-I/O-PRO version >= .42.
Enable "Simple Network Time Protocol"


Disable "Simple Network Time Protocol"

Activating "Simple Network Management

Protocol"

Deactivating "Simple Network Management

Protocol"
Activating EtherNet/IP protocol


Deactivating EtherNet/IP protocol

Activating WAGO services


Deactivating WAGO services
