Assigning The Ip Address Via Bootp - WAGO 750-363/0040-0000 Manual

102 Commissioning
8.3.4

Assigning the IP Address via BootP

A BootP server can be used to assign a fixed IP address.
Assigning the IP address using a BootP server depends on the respective BootP
program. Handling is described in the respective manual for the program or in the
respective integrated help texts.
Set the address selection switch to 0 for an IP assignment via software!
Set the address selection switch to "0" to disable the DIP switch.
Restart the fieldbus node after adjusting the address selection switch to apply the
configuration changes.
By default, DHCP is active in the delivery state of the head station.
Therefor it is necessary to enable BootP for IP address assignment via BootP,
e. g. via "WAGO Ethernet Settings" or via the WBM (see analog the chapters
"Activate DHCP via "WAGO Ethernet Settings" (without existing IP address)" or
"Activate DHCP via WBM (with existing IP address)").
Then the IP address assignment with BootP takes place automatically via a
BootP server in the network.
If there is no BootP server on your local PC, you can download a BootP server
free of charge from the Internet and install it on your PC.
Additional Information
Assigning IP addresses using a BootP server can be carried out in any Windows
and Linux operating system. Any BootP server may be used.
IP address assignment is not possible via the router!
The IP address is assigned via patch cable, switches or hubs. Addresses cannot
be assigned via routers.
When the BootP protocol is enabled the head station of fieldbus node expects
the BootP server to be permanently available. If there is no BootP server
available after a Power On reset, the network will remain inactive.
In order to use the IP address permanently, change it to "static" (see chapter
"Apply IP address permanently (option "static ")").
Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
WAGO-I/O-SYSTEM 750