WAGO 750-363/0040-0000 Manual page 124

124 Configuring via the Web-Based Management System (WBM) WAGO-I/O-SYSTEM 750
Switch Settings
Entry
Enable fast aging
Enable port mirroring
Ethernet MTU
Input data rate limit
Output data rate limit
Enable broadcast
storm protection
Sniffer Port
Mirror Port
Set the MTU value for fragmentation only!
Only set the value for MTU, i.e., the maximum packet size between client and
server, if you are using a tunnel protocol (e.g., 1452 for VPN) for ETHERNET
communication and the packets must be fragmented.
Setting the value is independent of the transmission mode selected.
Configure ETHERNET transmission mode correctly!
A fault configuration of the ETHERNET transmission mode may result in a lost
connection, poor network performance or faulty performance of the fieldbus
coupler/controller.
Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
Default value Description
Enable "Fast Aging"

"Fast Aging" ensures that the cache for the MAC
addresses is cleared faster in the switch. This may
be required if a redundancy system (e.g., using a Jet-

Ring network or comparable technology) needs to be
set up.
Disable "Fast Aging".

The time to discard the cache entries is five minutes.
Enable port mirroring

Port Mirroring is used for network diagnostics.
Packets are mirrored from one port (mirror port) to

another (sniffer port).
Disable port mirroring

Maximum packet size of a protocol, which can be
1500 transferred without fragmentation ("Maximum
Transmission Unit" - MTU).
Port
1 2
internal
The input limit rate limits network traffic when receiving.
No limit  The rate is indicated in megabits or kilobits per second. If
the limit is exceeded, packets are lost.
The output limit rate limits network traffic when sending.
No limit  The rate is indicated in megabits or kilobits per second. If
the limit is exceeded, packets are lost.
Activate broadcast storm protection. The maximum

number of incoming broadcast telegrams is limited
 
and packets affected by the limitation are discarded.
Broadcast storm protection disabled.

Select the sniffer port the mirror port should be mirrored to.
 
Select the mirror port which should be mirrored to the
  
sniffer port.