Administration; Table 43: Wbm Page "Administration - WAGO 750-363/0040-0000 Manual

116 Configuring via the Web-Based Management System (WBM) WAGO-I/O-SYSTEM 750
9.5

Administration

Use the "Administration" WBM page to set configuration options for basic
administration purposes, such as boot behavior, authentication, and SSL
certificate.
These configuration options are stored in non-volatile memory when the
[SUBMIT] button is pressed. Changes to the configuration options take effect
after the next power-on cycle or software reset.
Changing the passwords requires administrator rights and software reset!
You can only change the passwords as an administrator with the user rights
"admin" and the associated password.
Press the [Software Reset] button to restart the software for the setting changes
to take effect.
Note password restrictions!
The following restriction is applied for passwords:
• Max. 32 characters inclusive special characters.
Renew access after software reset!
If you initiate a software reset on this page, then the fieldbus coupler/controller
starts with the configurations previously loaded into the EEPROM and the
connection to the browser is interrupted.
If you changed the IP address previously, you have to use the changed IP
address to access the device from the browser.
You have not changed the IP address and performed other settings; you can
restore the connection by refreshing the browser.

Table 43: WBM Page "Administration"

Security Settings
Entry
Enable web-server
authentication
User Settings
Entry
User
Password
Confirm Password
Manual
Version 1.0.0
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
Default Description
Enable password protection to access the

Web interface

Disable password protection to access the

Web interface
Default Description
guest Select user permissions according to the default user
group ( see Chapter "WBM User Groups").
- Enter desired password (max. 32 characters
inclusive special characters).
- Enter desired password again to confirm.