GE Ecomagination AF-600 FP Programming Manual page 62

Parameter Description
P-44 d-axis Inductance Sat. (LdSat)
Range: Function:
0.0 mH [0 - 1000 Enter the inductance saturation of Ld.
*
mH] Ideally, this parameter has the same value
as parameter P-37 d-axis Inductance (Ld). If
the motor supplier provides an induction
curve, enter the induction value at 200% of
the nominal value.
P-45 q-axis Inductance Sat. (LqSat)
Range: Function:
0.0 mH [0 - 1000 This parameter corresponds to the
*
mH] inductance saturation of Lq. Ideally, this
parameter has the same value as
parameter P-38 q-axis Inductance (Lq). If the
motor supplier provides an induction curve,
enter the induction value at 200% of the
nominal value.
P-46 Position Detection Gain
Range: Function:
100 % [20 - Adjusts the amplitude of the test pulse
*
200 %] during position detection at start. Adjust
this parameter to improve the position
measurement.
P-47 Torque Calibration
Option:
[0] Off
*
[1] 1st start after pwr-up
[2] Every start
[3] 1st start with store
[4] Every start with store
P-48 Inductance Sat. Point
Range: Function:
35 % [1 - 500 %] Enter the induction saturation point.
*
P-62 Locked Rotor Protection
Option:
[0] Off
*
[1] On
P-63 Locked Rotor Detection Time [s]
Range:
0.10 s [0.05 - 1 s]
*
DET-620D
AF-600 FP™ Programming Guide
Function:
Function:
Function:
03/2016 All rights reserved.
3 3
61