Lg-## Logs & I/O Opt. Status - GE Ecomagination AF-600 FP Programming Manual

Parameter Description
3.18 LG-## Logs & I/O Opt. Status
3.18.1 LG-0# Maintenance Log
This group contains the last 10 preventive maintenance
events. Maintenance log 0 is the latest and maintenance
3 3
log 9 the oldest.
By selecting 1 of the logs and pressing [OK], the
maintenance item, action, and time of the occurrence are
shown in parameter LG-00 Maintenance Log: Item –
parameter LG-03 Maintenance Log: Date and Time.
The alarm log key allows access to both alarm log and
maintenance log.
LG-00 Maintenance Log: Item
Array [10]
For details about a fault code, refer to the design guide.
Range:
0 [0 - 255] Locate the meaning of the maintenance item in
*
LG-01 Maintenance Log: Action
Array [10]
For details about a fault code, refer to the design guide.
Range:
0 [0 - 255] Locate the meaning of the maintenance item in
*
LG-02 Maintenance Log: Time
Array [10]
Range:
0 s [0 - 2147483647 s] Shows when the logged event
*
LG-03 Maintenance Log: Date and Time
Array [10]
Range:
0 [0 - 0] Shows when the logged event occurred.
*
NOTICE
This requires that the date and time is
programmed in parameter K-70 Date and
Time.
Date format depends on the setting in
parameter K-71 Date Format, while the time format
depends on the setting in parameter K-72 Time
Format.
122
Function:
the description of parameter T-10 Maintenance
Item.
Function:
the description of parameter T-11 Maintenance
Action.
Function:
occurred. Time is measured in s since
last power-up.
Function:
LG-03 Maintenance Log: Date and Time
Array [10]
Range:
NOTICE
When mounting a Analog I/O option card, a battery
back-up of date and time is included.
3.18.2 LG-1# Fire Mode Log
The log covers the latest 10 faults which have been
suppressed by the Fire mode function. See parameter
group FB-0#, Fire Mode. The log can be viewed either via
the below parameters or by pressing [Alarm Log] on the
keypad and select Fire mode log. It is not possible to reset
the fire mode log.
LG-10 FireMode Log:Event
Range:
0 [0 - 255] This parameter contains an array with 10
*
LG-11 Fire Mode Log: Time
Range:
0 s [0 - 2147483647
*
s]
03/2016 All rights reserved.
Function:
NOTICE
The frequency converter has no back-up of
the clock function, and the set date/time
resets to default (2000-01-01 00:00) after a
power-down unless an Analog I/O Option
Module with Real Time Clock Battery Back
Up (OPCAIO) is installed. In
parameter K-79 Clock Fault it is possible to
program a warning in case the clock has not
been set properly, for example after a
power-down. Incorrect setting of the clock
affects the time stamps for the maintenance
events.
Function:
elements. The number read represent an error
code, which corresponds to a specific alarm. This
can be found in the Troubleshooting section in the
design guide.
Function:
This parameter contains an array with
10 elements. The parameter shows at
which time the logged event occurred.
Time is measured in seconds since the
first start of the motor.
DET-620D