GE Ecomagination AF-600 FP Programming Manual page 13

How to Program
Bottom section
(c) always shows the state of the frequency converter in
status mode.
2 2
Press [Status] to toggle between 3 status readout displays.
Operating variables with different formatting are shown in
each status screen.
Each value/measurement readout parameter selected in
parameter K-20 Display Line 1.1 Small to
parameter K-24 Display Line 3 Large has its own scale and
number of digits after a possible decimal point. Larger
numeric values are displayed with few digits after the
decimal point.
Ex.: Current readout
5.25 A; 15.2 A 105 A.
Status display I
This readout state is standard after start-up or restore.
Press [INFO] to obtain information about the value/
measurement linked to the displayed operating variables
(1.1, 1.2, 1.3, 2, and 3).
See the operating variables shown in the display in
Illustration 2.2. 1.1, 1.2, and 1.3 are shown in small size. 2
and 3 are shown in medium size.
Illustration 2.2 Example of Status Display I
Status display II
See the operating variables (1.1, 1.2, 1.3, and 2) shown in
the display in Illustration 2.3.
In the example, speed, motor current, motor power, and
frequency are selected as variables in the first and second
lines.
1.1, 1.2, and 1.3 are shown in small size. 2 is shown in
large size.
12
Illustration 2.3 Example of Status Display II
Status display III
This state displays the event and action of the Logic
Controller.
Illustration 2.4 Example of Status Display III
Display contrast adjustment
Press [Status] and [
Press [Status] and [
Illustration 2.5 Display Sections
03/2016 All rights reserved.
▲
] for darker display.
▼
] for brighter display.
DET-620D