Table of Contents
Advertisement
Parameter Description
EN-14 Link Duplex
Option:
3
3
[0]
Half Duplex
[1]
Full Duplex
*
EN-20 Control Instance
Range:
[None, 20, 21, 23,
100, 101, 103]
EN-21 Process Data Config Write
Range:
[[0 - 9] PCD read 0 - 9] Configuration of readable process
EN-22 Process Data Config Read
Range:
[[0 - 9] PCD read 0 - 9] Configuration of readable process
EN-27 Primary Master
Range:
0
[0 -
*
4294967295]
EN-28 Store Data Values
Option:
[0]
Off
*
[1]
Store All
set-ups
EN-29 Store Always
Option:
Function:
Activates function that always stores received
parameter data in non-volatile memory (EEPROM).
[0]
Off
*
[1]
On
104
Function:
Forces the duplex for each port to full or half
duplex. If parameter EN-12 Auto Negotiation is
set to: [ON], this parameter is read-only.
Function:
Read-only. Displays the connection to the
master. In Ethernet/IP: If no CIP
connection is present, None is displayed.
Function:
data.
Function:
data.
Function:
Controls the Master's access to the process
data. The value zero (0.0.0.0) means that
other masters can take control of the drive
immediately if the connection is lost or
closed. Setting an IP number means that
only a master with this value can establish a
connection for controlling the drive. In
systems with backup masters, this parameter
should be left to the value zero (0.0.0.0).
Function:
This parameter activates a function that stores
all parameter values in the non-volatile memory
(EEPROM) thus retaining parameter values at
power-down.
The parameter returns to [0] Off.
The store function is inactive.
All parameter values are stored in the non-
volatile memory, in all 5 set-ups.
EN-30 Warning parameter
Range:
[0000–
FFFF hex]
EN-31 Net Reference
Option:
Function:
Read-only. Displays the reference source in Instance
21/71.
[0]
Off Reference from the network is not active.
*
[1]
On Reference from the network is active.
EN-32 Net Control
Option:
Function:
Read-only. Displays the control source in Instance
21/71.
[0]
Off Control via the network is not active.
*
[1]
On Control via the network is active
EN-33 CIP Revision
Option:
[0] Major version (00 - 99)
[1] Minor version (00-99)
EN-34 CIP Product Code
Range:
201
[0 - 65535]
*
EN-35 EDS Parameter
Range:
0
*
03/2016 All rights reserved.
Function:
Read-only. Displays the Ethernet/IP specific 16-bit
status-word.
Bit
Description
0
Owned
1
Not used
2
Configured
3
Not used
4
Not used
5
Not used
6
Not used
7
Not used
8
Minor recoverable fault
9
Minor unrecoverable fault
10
Major recoverable fault
11
Major unrecoverable fault
12
Not used
13
Not used
14
Not used
15
Not used
Table 3.15 Bit Description
Function:
Read-only. Displays the CIP-version of
the option software.
Function:
Read-only. Shows the CIP product code.
Function:
[0 - 0]
DET-620D
Advertisement
Chapters
Table of Contents
