Introduction; Software Version; Copyright, Limitation Of Liability And Revision Rights; Approvals - GE Ecomagination AF-600 FP Programming Manual

Introduction

1 1
1 Introduction

1.1 Software Version

This guide can be used with all
AF-600 FP frequency converters
with software version 2.4 or later.
The actual software version
number can be read from
parameter ID-43 Software Version.
Table 1.1 Software Version
1.2 Copyright, Limitation of Liability and
Revision Rights
This publication contains information proprietary to GE. By
accepting and using this manual, the user agrees that the
information contained in this is used solely for operating
equipment from GE, or equipment from other vendors if
such equipment is intended for communication with GE
equipment over a serial communication link. This
publication is protected under the Copyright laws of
Denmark and most other countries.
GE does not warrant that a software program produced
according to the guidelines provided in this manual
functions properly in every physical, hardware, or software
environment.
Although GE has tested and reviewed the documentation
within this manual, GE makes no warranty or represen-
tation, neither expressed nor implied, concerning this
documentation, including its quality, performance, or
fitness for a particular purpose.
In no event shall GE be liable for direct, indirect, special,
incidental, or consequential damages arising out of the
use, or the inability to use information contained in this
manual, even if advised of the possibility of such damages.
In particular, GE is not responsible for any costs, including
but not limited to those incurred as a result of lost profits
or revenue, loss or damage of equipment, loss of computer
4
AF-600 FP
03/2016 All rights reserved.
programs, loss of data, the costs to substitute these, or any
claims by third parties.
GE reserves the right to revise this publication at any time
and to make changes to its contents without prior notice
or any obligation to notify former or present users of such
revisions or changes.
It has been assumed that all devices are sitting behind a
firewall that does packet filtering and the environment has
well-implemented restrictions on the software that can run
inside the firewall. All nodes are assumed to be "trusted"
nodes.

1.3 Approvals

1.4 Symbols

The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which could
result in minor or moderate injury. It may also be used
to alert against unsafe practices.
NOTICE
Indicates important information, including situations that
may result in damage to equipment or property.

1.5 Definitions

1.5.1 Frequency Converter

I
DRIVE,MAX
Maximum output current.
I
DRIVE, N
Rated output current supplied by the frequency converter.
U
DRIVE, MAX
Maximum output voltage.
DET-620D