Table of Contents
Advertisement
3
Installation
3.1
Overview
This section describes installation procedures for the Spectrum Series S-920 Dispensing System and
covers the following topics:
•
Uncrating and Placing the Dispensing System
•
Unpacking the Dispensing Chamber
•
Leveling the Dispensing System
•
Leveling the Scale
•
Setting Up the Service Station
•
Installing the Light Beacon
•
Installing the Laptop Computer
•
Installing the Camera
•
Anchoring the Dispensing System
3.2
Safety First
Operation of your S-920 Dispensing System involves heat, air pressure, electrical power, mechanical
devices, and the use of hazardous materials. It is essential that every person servicing or operating the
dispensing system fully understands all hazards, risks, and safety precautions. Refer to
for additional information.
CAUTION!
Installation procedures should only be performed by a trained service technician.
3.3
Facility Requirements
To ensure optimal performance and safety, it is necessary to install the dispensing system in a facility that
meets the requirements. If you have any questions about facility requirements, please contact Asymtek
Technical Support. See
3.4
Tools and Materials Needed
•
3 mm hex key
•
9/16-inch wrench
•
Band Cutter
•
Personal Protective Equipment
•
Hammer
•
Flat Bar
Installation
10.2 Facility Requirements
for detailed information.
•
1/2-inch wrench
•
Phillips Screwdriver (included in tool kit)
•
1 ½-inch wrench (included in tool kit)
•
Diagonal-cut pliers
•
Forklift
•
Box Level
Section 2 - Safety
3-1
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Asymtek Spectrum Series and is the answer not in the manual?