Nordson Asymtek Spectrum Series Installation, Operation & Maintenance Manual page 153

To place a program command in a Conveyor Block:
1. In the Fluidmove Main Window, select
The Programming Window opens.
2. Click on the
The Conveyor drop-down menu (Figure 6-24) opens.
Figure 6-24 Programming Window - Conveyor Block Commands
3. Select
Use Conveyor 1 Block
to dispense.
A Conveyor Block command similar to the one below will be inserted into your program.
1 USE CONVEYOR 1:
2 END USE CONVEYOR:
4. Move the cursor to the beginning of the
5. Click on the
A Teach Window opens.
6. Select the element you want to program from the Dispensing Elements toolbar and follow the
screen prompts.
7. Click on
Done
The dispensing command should be inserted between the
End Use Conveyor
8. Save the program.
A sample program is shown in Figure 6-25.
Operation
button on the Program Commands toolbar.
Conveyor
or
Use Conveyor 2 Block
Dispense Elements
when you are finished.
commands.
.
Teach a Program
depending on where you want
END USE CONVEYOR
button on the Program Commands toolbar.
Use Conveyor 1
command.
and
6-29