Material Safety; Preventing Dispensing System And Workpiece Damage - Nordson Asymtek Spectrum Series Installation, Operation & Maintenance Manual

•
Provide adequate space around the dispensing system to allow for movement of maintenance
and service personnel. Allow space for access doors and service panels to open fully.
•
Make sure all facility power sources are safely grounded.
•
Routinely inspect all air hoses and electrical cables for damage.
•
Make sure power cords and air supply hoses do not cross a walkway or aisle.
•
Before attempting to lift a load, take into consideration facility lifting and transport
precautions. See
•
Maintain a clean and orderly work area.
2.4.2

Material Safety

•
Follow Material Safety Data Sheet (MSDS) recommendations for the proper handling,
cleanup, and disposal of all materials and fluids and their containers (i.e., syringes, cups,
reservoirs, etc.) used with the dispensing system.
•
Follow MSDS recommendations for the proper handling and disposal of all materials when
cleaning dispensing equipment and spills.
•
Make sure the dispensing system ventilation is ON during handling and cleanup of all
materials used with the dispensing system.
•
Know the MSDS recommendations for treatment of injury resulting from exposure to
hazardous materials.
•
Always wear appropriate personal protective equipment (PPE) as recommended by facility
safety practices and the material manufacturer's MSDS.
•
When working with multiple fluids, refer to the MSDS to ensure the materials are
compatible.
•
If possible, save or recycle unused materials. Refer to the MSDS before saving or recycling
unused materials.
2.4.3

Preventing Dispensing System and Workpiece Damage

•
Immediately push the EMO button if dispensing system or a workpiece is in danger of
being damaged.
•
Use standard Electrostatic Discharge (ESD) precautions when working near sensitive
components. Always wear a grounding strap and connect it to the ESD ground before
handling workpieces.
•
Immediately contain and clean up any caustic or conductive fluid spills as recommended in
the material manufacturer's MSDS. If fluid gets into internal portions of the machine,
immediately contact Asymtek Technical Support.
•
Follow all recommended system maintenance procedures.
•
Always keep the dispensing area clear of any fallen workpieces or obstacles.
•
Ensure that no air intakes or exhaust grilles are blocked when the system is in operation.
Safety
2.5 Lifting and Transport Precautions.
2-3