Fluidmove For Windows Xp Software; Integral Height Sensor; Light Beacon; Low Air Pressure Alarm - Nordson Asymtek Spectrum Series Installation, Operation & Maintenance Manual

1.7.4.2 Dual Lane
The Dual Lane Conveyor allows parallel processing on two lanes for continuous dispensing, eliminating
lost time in non-dispensing activities, such as material flow-out and substrate loading and unloading. In
some applications, a 60 to 80 percent increase in throughput can be achieved with a dual lane versus a
single lane conveyor. The conveyors are independently controlled, allowing different-sized parts to be
processed in each lane for ultimate process flexibility.
1.7.5

Fluidmove for Windows XP Software

Fluidmove for Windows XP (FmXP) is Asymtek proprietary software for use in a Windows XP
environment, developed specifically for dispensing applications.
1.7.6

Integral Height Sensor

The Integral Height Sensor allows increased positional accuracy in fluid dispensing by automatically
controlling the gap of the dispense tip to the surface of the workpiece.
1.7.7

Light Beacon

The Light Beacon is an indicator device for the operator. The beacon signals a dispensing status condition
by displaying a colored light and/or issuing an audible alarm. See
1.7.8

Low Air Pressure Alarm

The Low Air Pressure Alarm sounds when the system air pressure is too low. The low air pressure
threshold value can be set through the Fluidmove software. Refer to the Fluidmove User Guide or Online
Help for additional information.
1.7.9

Mass Flow Calibration

Mass Flow Calibration (MFC) is a patented feature that enables the user to specify the mass to be
dispensed as a separate parameter within the dispensing elements. This is made possible by using a high
precision scale to take flow rate measurements. The Fluidmove software features a fluid manager where
the user specifies how the flow rate is to be taken. This helps to ensure a statistically meaningful flow rate
value is obtained. MFC has two major benefits. First, it ensures the right amount of material is dispensed
for each part from the beginning to the end. Second, it reduces setup times on a daily basis by
automatically compensating for changes in viscosity or fluid delivery flow rate.

1.7.10 Needle Heater

The Needle Heater is an RTD-controlled heating element that provides needle heat on the DV-7000 and
DV-8000 Dispensing Valves and nozzle heat for the DJ-9000 Dispense Jet. The Needle Heater heats the
dispensing fluid to maintain a consistent viscosity and flowrate. The Fluidmove software controls the
heater temperature.

1.7.11 Precision Pneumatics

1.7.11.1 Digital Gauges
The S-920 features digital valve, fluid, and coax/cooling pressure gauges for high accuracy and easy
setup. They regulate the air pressure required for the fluid reservoir. See
Gauges for additional information.
1-4
2.12 Light Beacon.
5.12 Initializing the Digital
Introduction