Servicing the Groomer Reel
Disassembling the Groomer Reel
Universal Groomer (Optional): Service and Repairs
g202019
1.
Groomer blade
2.
Sharp edge
Inspect the groomer reel blades frequently for any damage and wear. Straighten
the bent blades. Either replace the worn blades or reverse the individual blades
to put the sharpest blade edge forward
rounded to the midpoint of the blade tip must be reversed or replaced for best
groomer performance.
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, set the parking brake, and remove the key from the
key switch.
2. Remove the groomer reel from the cutting unit; refer to
Groomer Reel (page
g229841
1.
Groomer reel shaft
2.
Groomer blade (40 each)
3. Remove the locknut from either end of the shaft
Figure 222
3.
Midpoint
4.
Dull (rounded) edge
(Figure
9–12).
Figure 223
3.
Spacer (39 each)
4.
Locknut (2 each)
Page 9–14
222). The blades that are
Removing the
(Figure
223).
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E