Servicing The Grooming Brush (Optional) - Toro Greensmaster eFlex 1800 Service Manual

Servicing the Grooming Brush (Optional)

g229842
1. Brush element
2. Roll pin (2 each)
Universal Groomer (Optional): Service and Repairs
3. Brush shaft
4. J-bolt (2 each)
The optional grooming brush attaches to the groomer in place of the groomer
reel. The grooming brush is removed and installed from the groomer in the same
manner as the groomer reel; refer to
The grooming brush element or shaft can be serviced separately
To remove the spiral grooming brush from the shaft, remove the locknut and
J-bolt from both ends of the brush assembly and slide the brush from the shaft.
When assembling the spiral brush to the shaft, ensure that the J-bolts are
installed with the threaded portion on the outside of the brush and tighten the
locknuts to 2.3 to 2.8 N∙m (20 to 25 in-lb).
Figure 226
Groomer Reel (page
Page 9–18
5. Locknut (2 each)
6. Spiral brush
9–12).
(Figure
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
226).