Key Switch - Toro Greensmaster eFlex 1800 Service Manual

Key Switch

Testing the Key Switch
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
g202435
1. Key switch
2. Washer-head screw (4 each)
3. Console cover
The key switch allows the machine operation to be turned on and off. The key
switch has 3 positions: O
inputs for the TEC and is located on the switch panel
Check the key switch operation with the InfoCenter on the console. With the key
switch in the R position, the InfoCenter should allow the information screen
UN
to be displayed. With the InfoCenter in the diagnostics menu, choose the Key
Start and ensure that the switch state changes as the key switch is moved to
the S position and is then released. If the InfoCenter operation suggests a
TART
damaged key switch, proceed to the key switch testing below.
Note: If the eFlex machine is sitting idle for 5 minutes with the key switch in the
R position, the machine will shut off.
UN
Note: A damaged key switch may cause a #12 fault to be generated and
displayed on the InfoCenter. Refer to the
information on faults.
1. Park the machine on a level surface and place the traction lever in the
N position. Turn the key switch to the O
EUTRAL
key from the key switch.
2. Disconnect the battery pack; refer to
(page 5–7).
3. Remove the console cover from the handle to get access to the key switch
(Figure 98).
4. Disconnect the wire harness electrical connector from the key switch.
Figure 98
4. Lower handle
5. Switch panel
, R , and S . This switch is 1 of the several
FF UN TART
Faults Screen (page 5–26)
Connecting the Lithium Battery Pack
Page 5–47 Electrical System: Testing the Electrical Components
(Figure 98).
for
position and remove the
FF