Toro Greensmaster eFlex 1800 Service Manual page 297

Assembling the Height Adjuster Assembly (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
not tighten the flange nut at this time. Ensure that the height adjustment bolt
and 1 washer is above the slot in the side plate and 1 washer and locknut is
below the slot in the side plate.
3. Position front roller between the height adjuster assemblies and secure
height adjuster assembly to cutting unit side plate with carriage bolt and
flange nut. Do not tighten the flange nut at this time. Ensure the height
adjustment bolt and 1 washer is above slot in side plate and 1 washer and
locknut is below slot in side plate.
4. Install new cotter pins and clevis pins and secure the height adjustment rods
to the groomer gear box and idler arm.
5. Adjust the cutting unit height-of-cut; refer to Cutting Unit Operators Manual.
6. Check the groomer reel height and adjust as necessary.
g207293
1. Height adjustment knob
7. Adjust the flange nuts (item 8 in
adjustment rods until the springs are compressed to 16 mm (0.625 inch).
Figure 225
Figure 224) on the groomer height
Page 9–17 Universal Groomer (Optional): Service and Repairs