Adjusting the Reel Clutch (continued)
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
g203643
1.
Reel clutch lever
2.
Reel clutch pulley
6. Back out the set screw in reel clutch lever until the reel clutch hub causes
the tips of the reel drive hub teeth to contact the mating reel clutch pulley
(Item 2 in
Figure
22).
7. While maintaining light pressure on the reel clutch lever, rotate the set screw
clockwise until a gap of 1.0 to 1.5 mm (0.040 to 0.060 inch) is attained
between the reel drive hub and the reel clutch hub.
8. Tighten the jam nut to secure the adjustment. Ensure that the set screw does
not rotate while tightening the jam nut.
9. Install the rubber plug into the front of the transmission.
10. Install the reel cable to the casting slot of the transmission and confirm that
the cable spring length is properly set; refer to
Cable (page
6–10).
11. Connect the battery pack; refer to
(page
4–3).
Figure 22
3.
Reel drive hub
4.
Reel clutch hub
Connecting the Lithium Battery Pack
Page 4–13
Traction and Reel Drive System: Adjustments
Replacing the Reel Clutch