Servicing The Roller - Toro Greensmaster eFlex 1800 Service Manual

Servicing the Roller

Disassembling the Roller
Cutting Unit: Service and Repairs
g206889
1. Bearing locknut
2. V-ring
3. Seal
1. To hold the roller shaft (item 7 in
install a 3/8-24 UNF 2B screw into threaded end of the roller shaft and secure
the screw in place with the jam nut. While retaining the shaft, remove the
bearing locknut from each end of the roller shaft.
2. Remove the V-ring (item 2 in
3. Carefully inspect the seating surface and threads of the bearing locknuts
(item 1 in Figure 170). Replace the locknut if there is any damage.
4. Loosely secure the roller assembly in a bench vise and lightly tap one end
of the roller shaft until the seal and bearing are removed from the roller
cavity. Remove the second seal and bearing from the roller cavity by tapping
on the shaft.
5. Clean the bearing cavity in the roller and remove any rust with crocus cloth.
Figure 170
4. Ball bearing
5. Wiehle roller
6. Smooth roller
Figure 170) for bearing locknut removal,
Figure 170) from each end of the roller.
Page 7–22
7. Roller shaft
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E