Lithium Battery Pack Charger (For Models 04042, 04043 And 04046) - Toro Greensmaster eFlex 1800 Service Manual

Lithium Battery Pack Charger (for Models 04042, 04043 and 04046)

Electrical System: Service and Repairs
g202196
1. Power supply cord
2. Fuse tray
3. Output cord
g202791
1. Power switch
The lithium battery pack charger
(42 V to 64 V @ 100% state of charge), 35 Ah lithium ion battery pack that is
used to power the eFlex. The charger communicates via CAN with the battery
management system (BMS) located within the lithium battery pack. Refer to the
eFlex Operator's Manual, Lithium Battery Pack Charger Operator's Manual, and
Lithium Battery Pack Charger Operation (for Models 04042, 04043 and 04046)
(page 5–10) in this chapter for additional information about the eFlex battery
charger.
Note: Ensure that the charger is connected to the battery pack, plugged into a
wall outlet, and turned O
The LED's and LCD message display on the charger should identify charger
status during normal operation. If the LED's and LCD display do not illuminate
when the charger is connected to the power supply with the power switch turned
O , ensure that the AC power supply is available for the charger. Also, consider
N
that the charger fuse located in the fuse tray under the charger power switch
may be damaged.
Figure 129
4. Input power socket
5. Power switch
6. LCD message display
Figure 130
2. Input power socket
(Figure 129) is used to charge the nominal 53 V
whenever the machine is not in use.
N
Page 5–88
7. On LED
8. Charging LED
9. Ready LED
3. Fuse tray
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E