Groomer Cover (Counter Rotating Groomer Drive) - Toro Greensmaster eFlex 1800 Service Manual

Groomer Cover (Counter Rotating Groomer Drive)

Removing the Groomer Cover (Counter Rotating Groomer Drive)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
On eFlex machines with the counter rotating groomer, the groomer cover
includes a handle which engages and disengages the groomer drive. When the
handle is rotated toward the front of the machine, the groomer is engaged.
1. Park machine on level surface. Turn key switch to the O
remove key from the switch. Ensure that the traction lever is in the N
position.
2. Disconnect the battery pack; refer to
(page 8–3).
3. Ensure that the handle on groomer cover is rotated toward front of machine
so that the groomer drive is engaged.
g228144
1. Groomer cover assembly
2. Flange-head screw (5 each)
4. Remove groomer cover assembly from machine
A. Remove 5 flange-head screws that secure groomer cover assembly to
right drive plate.
B. Remove groomer cover assembly and gasket from machine. Discard
gasket.
5. If necessary, remove shaft from groomer cover
A. Loosen set screw on top of shaft and slide handle from shaft.
B. Remove retaining ring and thrust washer from shaft.
C. Remove plunger detent from groomer cover.
D. Slide shaft out of groomer cover. Remove and discard O-ring from shaft.
6. Remove grease from inside groomer cover and right drive plate on cutting
unit. Thoroughly clean and inspect all groomer drive components.
Connecting the Lithium Battery Pack
Figure 186
3. Gasket
4. Handle
Page 8–7 Belt Driven Groomer: Service and Repairs
position and
FF
EUTRAL
(Figure 186):
(Figure 187):