Toro Greensmaster eFlex 1800 Service Manual page 241

Removing the Cutting Unit Assembly
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
Note: Removal of the cutting unit can be completed by removing the right side
plate from the cutting unit crossmember. The left side plate (including the reel
drive assembly) does not have to be removed from the crossmember when
using the following procedure.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury.
Use heavy gloves when handling the bedbar.
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Ensure that the traction lever is in
the N position.
EUTRAL
2. Disconnect the battery pack; refer to
(page 7–3).
3. Remove the cutting unit from the machine and place the cutting unit on
a flat work area.
g207105
1. Reel pulley
4. Remove the reel drive cover and belt from the reel drive assembly,
and remove the reel pulley from the reel driveshaft; refer to
Traction and Reel Drive System (page 4–1)
components.
If the reel driveshaft (item 5 in
appropriate wrench or socket on 1 inch hex surface of shaft. Do
not use 1/2 inch extension on the end of the reel driveshaft when
loosening or tightening the driveshaft. The 1/2 inch hex is intended
for backlapping only.
CAUTION
Connecting the Lithium Battery Pack
Figure 177
2. Belt
IMPORTANT
Figure 178) is to be loosened, use
Page 7–27
FF
3. Reel drive cover
Chapter 4:
for procedure to remove these
Cutting Unit: Service and Repairs
position,