Cutting Unit - Toro Greensmaster eFlex 1800 Service Manual

Cutting Unit

g207099
Specifications and Maintenance: Specifications
Reel construction: 12.7 cm (5 inches) diameter, 11 or 14 carbon steel blades
welded to 5 stamped steel spiders. High strength low alloy steel blades are
through hardened and impact resistant.
Frame construction: Precision machined die cast aluminum crossmember with
2 bolt-on die-cast aluminum side plates.
Height-of-cut: Cutting height is adjusted on the front roller by 2 vertical screws
and held by 2 locknuts. Standard bench height of cut range is 1.6 to 12.7 mm
(0.062 to 0.500 inch) depending on type of bedknife installed. An optional high
height of cut kit is available for higher HOC adjustments. Effective HOC may vary
depending on turf conditions, type of bedknife, rollers, and attachments installed.
Clip: Clip frequency is adjusted by moving the pulleys on the cutting unit reel
drive housing. 6 clip adjustments are possible based on pulley configuration.
Rollers: The rear roller is a 5.1 cm (2 inches) diameter aluminum full roller. The
front roller is a 6.3 cm (2.5 inches) diameter roller that is chosen from a variety of
configurations (narrow spaced Wiehle front roller is shown in
Bedknife and bedbar: Single edged Edgemax™ bedknife (solid tool steel
construction) used with 11 and 14 blade cutting unit. A cast iron bedbar is
fastened to the cutting unit. Other optional bedknives and a less aggressive
bedbar are available.
Grass shield: Non-adjustable shield with adjustable cut-off bar to improve grass
discharge from reel in wet conditions.
Counterbalance weight: A cast iron weight mounted on right end of the cutting
unit balances the cutting unit.
Figure 4
Page 2–4
Figure 4).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E