Separating The Cutting Unit From The Traction Unit - Toro Greensmaster eFlex 1800 Service Manual

Separating the Cutting Unit from the Traction Unit

Cutting Unit: General Information
g207104
1. Locking pin
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Ensure that the traction lever is in
the N position.
EUTRAL
2. Disconnect the battery pack; refer to
(page 7–3).
3. Lower the kickstand and push in the locking pin to lock the kickstand in the
service position. Allow the kickstand and machine to rest against the locking
pin (Figure 152).
4. Remove the grass basket from the cutting unit, if installed.
g203645
1. Telescoping coupler
5. Slide the telescoping coupler off the cutting unit hex shaft
Figure 152
eFlex 2120 Model 04046 (shown)
2. Kickstand
Connecting the Lithium Battery Pack
Figure 153
2. Cutting unit hex shaft
Page 7–4
FF
(Figure 153).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
position,