Transmission Drum Drive System
g205738
1.
Driven pulley (traction drum drive)
2.
Ball bearing (2 each)
3.
Wave washer
4.
Spacer
5.
Transmission housing
Disassembling the Transmission Drum Drive System
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
6.
Washer-head screw (4 each)
7.
Flange nut
8.
Driven pulley
9.
Hardened washer (2 each)
10.
Flange-head screw (2 each)
The transmission removal from the machine is not necessary to service the
transmission drum drive system shown in
drive components can be accessed by removing the battery pack from the frame,
removing the transmission cover, and removing the drive belt.
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Disconnect the battery pack; refer
to
Connecting the Lithium Battery Pack (page
2. Remove the transmission drive belt; refer to
4–38).
3. Remove the flange-head screw (item 10 in
that secure the driven pulley to the shaft. Slide the pulley from the shaft.
Locate and retrieve the woodruff key.
4. Remove the drum drive belt from the machine; refer to
(page
4–21).
5. Slide the traction drum drive driven pulley (item 1 in
extension housing.
Figure 54
11.
12.
13.
Figure
Page 4–53
Traction and Reel Drive System: Service and Repairs
Bolt
Extension housing
Woodruff key
54. The transmission drum
FF
4–3).
Transmission Drive Belt (page
Figure
54) and hardened washer
Drum Drive Belt
Figure
54) from the
position,