Special Tools
Modified Socket for Reel Clutch Bearing Collar
Socket Modification
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
g203657
1.
Hub flat location
The modified socket is used to remove and install the reel clutch bearing
collar when servicing the transmission reel clutch shaft
Transmission Reel Drive System (page 4–43)
servicing the reel clutch shaft assembly.
1. Ensure that the socket (15 mm or 9/16 inch) to be modified fits over the reel
clutch shaft bearing collar.
g203658
2. Drill a hole or grind slots in the socket walls to allow a 5/32 inch pin to extend
through the socket. A modified socket with ground slots is shown in
Figure 14
2.
Reel clutch shaft
for complete information on
Figure 15
Page 4–7
Traction and Reel Drive System: Special Tools
3.
Bearing collar
(Figure
14). Refer to
Figure
15.