Disengaging The Drum Drive From The Transmission - Toro Greensmaster eFlex 1800 Service Manual

Disengaging the Drum Drive from the Transmission

Traction and Reel Drive System: General Information
The traction drum is driven by a multi-ribbed belt that is tensioned with a
spring loaded idler assembly. To disengage the traction drum drive from the
transmission, do the following procedure:
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Disconnect the battery pack; refer
to Connecting the Lithium Battery Pack (page
g203650
1. Traction lever (engaged)
2. Locate the traction engage/disengage lever next to the right drive housing
drum (Figure 11).
Be careful when rotating the traction engage/disengage lever. The
lever is spring loaded and may cause personal injury.
Push the lever from the front when removing belt tension to prevent
unexpected movement of the lever.
3. Rotate the traction engage/disengage lever toward the rear of the machine to
the disengaged position to remove tension from the drum drive belt.
4. To engage the drum drive, rotate the traction engage/disengage lever to the
engaged position by rotating the lever toward the front of the machine.
5. Connect the battery pack; refer to
(page 4–3).
Figure 11
2. Right handle clamp
CAUTION
Connecting the Lithium Battery Pack
Page 4–4
FF
4–3).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
position,