Toro Greensmaster eFlex 1800 Service Manual page 117

Removing the Rotor (continued)
Installing the Rotor
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
g202295
1. Torx-head screw (6 each)
2. Motor cover
3. O-ring
4. Bearing
5. Bearing
2. Remove the 6 torx-head screws that secure the motor cover
Note: Do not remove the cover from the motor assembly.
3. Secure the tool set base plate to the motor housing with the 4 cover screws.
4. Install the threaded shaft into the base plate.
The rotor magnets are very powerful and can cause the rotor to
shift position very rapidly during removal. Be cautious during rotor
removal to prevent component damage or personal injury.
5. Turn the threaded shaft with handle to remove the rotor and motor cover
from the motor housing. Support the rotor to prevent it from falling from the
housing during removal.
6. Leave the threaded shaft installed in same position in the base plate for
rotor installation purposes.
1. Secure the tool set base plate to the motor housing with the 4 cover screws.
2. Ensure that the threaded shaft is installed into the base plate so that the end
of the threaded shaft prevents the rotor body from entering the motor housing.
The rotor magnets are very powerful and can cause the rotor to shift
position very rapidly during installation. Be cautious during rotor
installation to prevent component damage or personal injury.
Figure 70
6. O-ring
7. Housing assembly
8. Rotor
9. Wave washer
10. O-ring
IMPORTANT
IMPORTANT
Page 5–17
(Figure 70).
Electrical System: Special Tools