Lift Arm Assembly - Toro Greensmaster eFlex 1800 Service Manual

Lift Arm Assembly

g228310
1. HOC groomer arm (left)
2. Flange nut
3. Grooved pin
4. E-ring
5. Groomer lift rod
6. Lock screw
Disassembling the Lift Arm Assembly
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
7. Bushing
8. Lift arm assembly (left)
9. Detent spring
10. Spring washer
11. Bolt
12. Bushing
1. Park machine on level surface. Turn key switch to the O
remove key from the switch. Ensure that the traction lever is in the N
position. Engage parking brake.
2. Disconnect the battery pack; refer to
(page 8–3).
3. Remove flange nut (item 2 in
groomer arm. Remove locknut and spring washer that secure lift arm to side
plate. Loosen lock screw completely.
4. Remove lift arm from cutting unit.
5. Disassemble lift arm
Note: Right and left side HOC groomer arms and lift arm assemblies are
different; other components shown in
sides of cutting unit.
Note: Grooved pin (item 3 in
lift arm assembly.
Figure 212
13.
14.
15.
16.
17.
18.
Connecting the Lithium Battery Pack
Figure 212) that secures lift arm to HOC
(Figure 212).
Figure 212
Figure 212) is used to retain lock screw to
Page 8–29
Wave washer
Groomer adjuster
Side plate (left)
Locknut
Spring washer
Bushing
position and
FF
are the same on both
Belt Driven Groomer: Service and Repairs
EUTRAL