Cutting Unit Assembly - Toro Greensmaster eFlex 1800 Service Manual

Cutting Unit Assembly

g206895
1. Cutting unit assembly
2. Right pitch arm
3. Compression spring (2 each)
4. Hex nut
5. O-ring
6. Weight
Cutting Unit: Service and Repairs
eFlex 2100/2120
7. Flange-head screw (2 each)
8. Shoulder bolt (2 each per side plate) 14.
9. Right side plate
10. Sensor target plate
11. Grass shield
12. Flange nut (2 each per side plate)
Note: This section provides the procedure for removing and installing the cutting
unit assembly (cutting unit, flocked seals, reel bearings, bearing lock screw, and
reel nut) from the cutting unit; refer to
7–31) for information on servicing the cutting unit assembly.
Note: EFlex 2100/2120 cutting units use shoulder bolts and flange nuts to
secure the side plates to the crossmember as shown in
1800 cutting units, square nuts are used instead of flange nuts. Cutting unit
service procedures are the same on all models.
Figure 176
13.
15.
16.
Servicing the Cutting Unit Assembly (page
Page 7–26
Crossmember
Left side plate
Flat wire spring
Left pitch arm
Figure 176. On eFlex
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E