Rear Roller - Toro Greensmaster eFlex 1800 Service Manual

Rear Roller

Removing the Rear Roller
Cutting Unit: Service and Repairs
g206888
1. Rear roller assembly
2. Flange nut
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Ensure that the traction lever is in
the N position.
EUTRAL
2. Disconnect the battery pack; refer to
(page 7–3).
3. Remove the cutting unit from the machine and place on a level working
surface. Place the support blocks under the bedbar to raise the rear roller
from work surface.
4. Loosen the 2 flange nuts that secure the rear roller shaft to each rear roller
bracket.
5. On one of the rear roller brackets:
Note: On cutting units equipped with optional high height-of-cut kit, there will
be additional roller shims installed between the rear roller bracket and the
cutting unit side plate.
A. For assembly purposes, note the quantity and location of the roller shims.
B. Remove the flange nuts and socket-head screws that secure the rear
roller bracket and roller shims to the cutting unit side plate.
C. Remove the roller bracket and roller shims from the rear roller and cutting
unit.
6. Slide the rear roller assembly from the remaining rear roller bracket on the
cutting unit.
7. If necessary, remove the second rear roller bracket and roller shims from
the cutting unit.
Figure 169
3. Roller shim
4. Roller height spacer
Connecting the Lithium Battery Pack
Page 7–20
5. Shaft retainer
6. Socket-head screw
FF
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
position,