Toro Greensmaster eFlex 1800 Service Manual page 247

Assembling the Cutting Unit (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
When installing the reel driveshaft (item 5 in
appropriate wrench or socket on 1 inch hex surface of shaft. Do
not use 1/2 inch extension on the end of the reel driveshaft when
loosening or tightening the driveshaft. The 1/2 inch hex is intended
for backlapping only.
4. Install the bearing lock screw (item 4 in
into the reel shaft to secure the bearings. The reel driveshaft has left-hand
threads and should be installed in the end of the reel shaft identified with a
groove that is just inside of reel spider.
Note: Installation torque for bearing lock screw and reel driveshaft is 123 to
149 N∙m (90 to 110 ft-lb). It is easiest to torque these items after the cutting
unit is installed in the cutting unit frame; refer to
Assembly (page 7–27)
IMPORTANT
Figure
and Installing the Cutting Unit Assembly (page
Page 7–33
Figure 179), use
179) and reel driveshaft
Removing the Cutting Unit
Cutting Unit: Service and Repairs
7–29).