Adjusting The Reel Clutch - Toro Greensmaster eFlex 1800 Service Manual

Adjusting the Reel Clutch

Traction and Reel Drive System: Adjustments
To adjust the reel clutch, do the following procedure:
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Disconnect the battery pack; refer
to Connecting the Lithium Battery Pack (page
g203642
1. Reel drive hub tooth
2. Reel drive hub
3. Reel clutch hub
4. Gap location
2. Remove the rubber plug from the front of the transmission to view the reel
drive clutch components
3. Release the clutch cable spring tension by removing the reel clutch cable
from the casting slot of the transmission as follows:
A. Loosen the upper jam nut that secures the reel cable to the casting slot
of the transmission.
B. Lift the cable free from the casting slot of the transmission.
4. Loosen the jam nut that secures the set screw position in the reel clutch
lever (Figure 21).
5. Apply a light upward pressure against the reel clutch lever.
Figure 21
5. Reel clutch lever
6. Set screw
7. Jam nut
(Figure 21).
Page 4–12
FF
4–3).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
position,