Groomer Reel - Toro Reelmaster 3100-D Service Manual

Groomer Reel

g343766
1. Groomer reel
2. Shaft clamp (4)
Removing the Groomer Reel
Reelmaster ® 3100-D/3105-D
20252SL Rev A
Remove the groomer reel to replace individual groomer blades or replace the
shaft. The groomer reel can be reversed to provide additional blade life.
1. Park machine on a clean and level surface, lower cutting units completely to
the ground, stop engine, engage parking brake and remove key from the key
switch. If desired, remove cutting unit from machine (refer to Traction Unit
Operator's Manual).
Contact with the reel or other cutting unit parts can result in personal
injury. Use heavy gloves when handling the groomer reel.
2. Carefully remove the four (item 4 in
shaft clamps securing the groomer reel to the output and stub shafts.
3. Lift the groomer reel from the cutting unit.
4. Inspect seal, shields, bushing and bearings for wear or damage. Replace
components as needed (refer to
Assembly (page 9–13)).
Figure 214
3. Cap screw (4)
4. Jam nut (4)
CAUTION
Figure
Gear Box Assembly (page 9–5)
Page 9–15 Universal Groomer (Optional): Service and Repairs
214) jam nuts, cap screws and
and Idler