Toro Greensmaster eFlex 1800 Service Manual page 173

Assembling the Electric Motor (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
5. Lubricate new O-rings (items 10 and 7 in
(refer to Dielectric Gel (page
the motor cover. Place the wave washer in the cover.
6. Carefully slide the motor cover onto the rotor until it contacts the motor
housing. Secure the cover with the 6 torx-head screws.
7. Ensure that the rotor rotates before continuing with motor assembly.
8. Place the wave washer into the housing bore for the output gear bearing.
9. Ensure that the output gear area of the motor housing has clean grease
remaining in housing. If grease was cleaned from housing, install 15 ml of
new NLGI grade 00 grease into the housing during motor assembly.
10. Slide the output gear assembly (items 11, 14, and 12 in
front of the housing. Ensure that the output gear teeth mesh with the rotor
gear.
g202786
1. Gearbox cover
2. Output gear
11. Install the shaft seal (item 1 in
shaft seal into the front cover until it is flush with the cover surface. The shaft
seal should have the seal lip toward the inside of the motor
12. Lubricate new O-rings (items 3 and 4 in
(refer to Dielectric Gel (page
in the gearbox cover.
Ensure that you do not damage the shaft seal when installing the
gearbox cover.
13. Carefully slide the gearbox cover onto the output gear shaft until it contacts
the motor housing. Secure the cover with the 6 torx-head screws.
14. Torque all the torx-head screws (item 9 in
and motor cover to 4 to 5 N∙m (35 to 45 in-lb).
Figure
2–15)) and install the O-rings into the grooves in
Figure 120
3. Shaft seal
Figure 119) into the gearbox cover. Press the
Figure
2–15)) and install the O-rings into the grooves
IMPORTANT
Figure
Page 5–73
119) with dielectric lubricant
Figure 119) into the
(Figure 120).
119) with dielectric lubricant
119) on the gearbox cover
Electrical System: Service and Repairs