Servicing The Reel Assembly - Toro Reelmaster 4500–D Service Manual

Servicing the Reel Assembly

Disassembly:
1. Remove the guards from each end of the cutting unit
and the front and rear roller assemblies (Fig. 19).
2. Remove the shoulder bolts, bushings and spacers
from each end of the unit and remove the bedbar/bed-
knife assembly (Fig. 20).
3. Remove the inboard locknut from the adjuster pin, the
fasteners for the bracket and remove the adjusting han-
dle assembly from the side plate (Fig. 20).
Reelmaster 4500–D
1. Guard
2. Mounting fasteners
3. Bedbar mounting assembly
1. Locknut
2. Belleville washer
3. Shoulder bolt
Page 7 – 13
Figure 19
4. Adjusting assembly
5. Dust cap
Figure 20
4. Bearing housing
5. Reel shaft
6. Flange bushing
Cutting Units