Ez Turn Switch - Toro Greensmaster eFlex 1800 Service Manual

EZ Turn Switch

g202439
1. EZ turn switch
2. Washer-head screw (4 each)
3. Console cover
Checking the Operation of EZ Turn Switch
Testing the EZ Turn Switch
Electrical System: Testing the Electrical Components
The EZ turn switch allows the EZ turn feature to be turned on and off. This
switch is 1 of the several inputs for the TEC. The EZ turn switch is located on
the switch panel (Figure
Note: The EZ turn function is only active when the machine is being operated
with the cutting unit engaged. Also, the EZ turn switch and EZ turn sensor are in
series so both switch and sensor have to be O
O . If either the switch or the sensor is O
N
Check the operation of EZ turn switch with the InfoCenter on the console. With
the key switch in the R
choose the EZ Turn and ensure that the switch state changes as the switch is
toggled between O and O
N
the switch state does not change when using the InfoCenter.
1. Park the machine on a level surface and place the traction lever in the
N position. Turn the key switch to the O
EUTRAL
key from the key switch.
2. Disconnect the battery pack; refer to
(page 5–7).
3. Remove the console cover from the handle to get access to the EZ turn
switch (Figure 106).
4. Disconnect the EZ turn switch connector from the machine wire harness.
Figure 106
4. Lower handle
5. Switch panel
106).
, the EZ Turn function will be O
FF
position and the InfoCenter in the diagnostics menu,
UN
. Further EZ turn switch testing is necessary only if
FF
Connecting the Lithium Battery Pack
Page 5–56
for the EZ Turn function being
N
position and remove the
FF
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
.
FF