Servicing The Electric Motor - Toro Greensmaster eFlex 1800 Service Manual

Servicing the Electric Motor

g202785
1. Shaft seal
2. Gearbox cover
3. O-ring (2 each)
4. O-ring
5. Rotor
Disassembling the Electric Motor
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
6. Wave washer (2 each)
7. O-ring
8. Motor cover
9. Torx-head screw (12 each)
10. O-ring
Note: If the motor housing, controller, or cable damage occurs, the electric motor
replacement is necessary. These components are not available separately.
Note: If problems with electric motor exist, an advisory or fault may be identified
on the InfoCenter display. Refer to the
information on advisories and faults.
1. Remove the 6 torx-head screws that secure the gearbox cover (item 2 in
Figure 119) to the front of the motor housing.
2. Carefully slide the gearbox cover from the front of the motor.
3. Remove and discard the O-rings (items 3 and 4 in
gearbox cover.
4. Slide the output gear assembly (items 11, 14, and 12 in
motor housing, and remove the wave washer.
Figure 119
11.
12.
13.
14.
InfoCenter Display (page 5–19)
Page 5–71
Bearing (2 each)
Bearing (2 each)
Housing/controller/cable assembly
Output gear
for
Figure 119) from the
Figure 119) from the
Electrical System: Service and Repairs