Service And Repairs; Backlapping - Toro Greensmaster eFlex 1800 Service Manual

Service and Repairs

Backlapping

Cutting Unit: Service and Repairs
To avoid personal injury or death:
• Do not place your hands or feet in the reel area while backlapping.
Stay away from the reel when backlapping.
• Do not attempt to restart the reel by hand or foot.
• Do not adjust the cutting unit while backlapping.
• Do not use a short handled paint brush for applying lapping
compound. Toro Part No. TOR299100 backlapping brush
assembly (refer to
available from your local Authorized Toro Distributor.
Note: Additional instructions and procedures on backlapping are available in
the Toro General Service Training Book, Reel Mower Basics (Toro Part No.
09168SL).
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the key switch. Ensure that the traction lever is in
the N position.
EUTRAL
2. Disconnect the battery pack; refer to
(page 7–3).
g206880
1. Telescoping coupler
3. The backlapping operation can be done with the cutting unit either removed or
attached to the traction unit. If the cutting unit is attached to the traction unit,
slide the telescoping coupler off the cutting unit hex shaft before backlapping.
Also, ensure that the reel drive lever is disengaged
4. Make initial reel to the bedknife adjustments appropriate for backlapping on
the cutting unit.
DANGER
Backlapping Brush Assembly (page
Connecting the Lithium Battery Pack
Figure 156
2. Cutting unit hex shaft
Page 7–8
2–16)) is
FF
(Figure 156).
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
position,