Bedbar Assembly - Toro Greensmaster eFlex 1800 Service Manual

Bedbar Assembly

g206881
1. Bedbar adjuster shaft
(2 each)
2. Bedknife
3. Detent (2 each)
4. Bolt (2 each)
5. Bedbar
6. Metal washer (4 each)
Removing the Bedbar
Cutting Unit: Service and Repairs
eFlex 2100/2120
7. Plastic washer (4 each)
8. Screw (13 each)
9. Locknut (2 each)
10. Compression spring (2 each)
11. Washer (2 each)
12. Bedbar adjuster screw
(2 each)
1. Park the machine on a level surface, turn the key switch to the O
and remove the key from the switch. Ensure that the traction lever is in the
N position.
EUTRAL
2. Disconnect the battery pack; refer to
(page 7–3).
3. Remove the cutting unit from the machine and place the cutting unit on
a flat work area.
Figure 159
13.
14.
15.
16.
17.
18.
Connecting the Lithium Battery Pack
Page 7–10
Retaining ring (2 each)
Wave washer (2 each)
Nylon bushing (2 each)
Bedbar pivot bolt (2 each)
Locknut (2 each)
Rubber bushing (2 each)
FF
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
position