Replacing The Grooming Reel Bearing - Toro Greensmaster eFlex 1800 Service Manual

Replacing the Grooming Reel Bearing

Removing the Grooming Reel Bearing
Belt Driven Groomer: Service and Repairs
1. Park machine on level surface. Turn key switch to the O
remove key from the switch. Ensure that the traction lever is in the N
position. Engage parking brake.
2. Disconnect the battery pack; refer to
(page 8–3).
3. Remove the cutting unit from the machine and place cutting unit on a flat
work area.
4. To remove groomer drive plate assembly from right side of cutting unit,
remove front roller, grooming reel, and then drive plate assembly; refer to
Grooming Reel (Forward Rotating Groomer Drive) (page 8–10)
Reel (Counter Rotating Groomer Drive) (page
g228298
1. Cutting unit
5. To remove support plate assembly from left side of cutting unit
A. Remove reel drive cover, drive belt, reel pulley and then reel drive
assembly from cutting unit; refer to
g228299
1. Front roller bolt
2. Grooming reel assembly
B. Remove locknut and spring washer that secure left groomer arm lift rod
to support plate
Connecting the Lithium Battery Pack
Figure 200
2. Reel drive assembly
Reel Drive Assembly (page
Figure 201
3. Locknut
4. Spring washer
(Figure 201).Remove support plate from cutting unit.
Page 8–20
position and
FF
or
8–14).
3. Left support plate
(Figure
5. Groomer arm lift rod
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
EUTRAL
Grooming
200):
4–16).