Table of Contents
Advertisement
Control via Web server
For control over a Web server, communications are performed between the external
controller and the E4981A through a LAN, regarding the E4981A as a Web server. You can
control the E4981A and send SCPI commands from the external controller by displaying
the E4981A's front panel in the external controller with Internet Explorer (IE6.0 SP2 or
later).
In addition, you can import the screen and recall the measurement data.
Preparing External Controller
As in the case of the SICL-LAN server, you need to set the I/O interface of the external
controller in advance to establish communication to the E4981A using the TCP/IP
protocol. For the procedure, refer
"Control over SICL-LAN server"
Control using web server
The following steps show how to control the E4981A using Internet Explorer.
Step 1. Start Internet Explorer.
Step 2. Type <IP Address> in the address field and press the enter key.
Enter CURRENT IP ADDR on the E4981A's SYSTEM CONFIG page for an IP address.
Step 3. The Web server's start screen appears.
Figure 2-6
Web Server Start Screen
Chapter 2
Overview of Remote Control
LAN remote control system
to"Preparing the external controller" on page 24
section.
of
29
Advertisement
Table of Contents
