Source:voltage[:Level][:Immediate][:Amplitude] - Keysight Technologies E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude]

Syntax :SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude] <numeric>[mV|V]
:SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude]?
Description Sets the measurement signal level.
Parameters
Description
Range
Initial value
Unit
Resolution
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
NOTE
A fraction below the resolution is rounded off. MAX or MIN can be used to specify the
parameters.
Query response {numeric}<newline><^END>
Equivalent key [
Meas Setup
sequence
264
Measurement signal level
100m to 1
1
V
10m
] - LEVEL
<numeric>
Chapter 10