[:Sense][:Fimpedance]:Contact1:Verify:threshold2 - Keysight Technologies E4981A Programming Manual

Command Reference
E4981A SCPI Commands

[:SENSe][:FIMPedance]:CONTact1:VERify:THReshold2

Syntax [:SENSe][:FIMPedance]:CONTact1:VERify:THReshold2 <numeric>
[:SENSe][:FIMPedance]:CONTact1:VERify:THReshold2?
Description Sets/Gets the Threshold2 value for Contact check. Threshold2 is a parameter which is
proportional contact resistance of Lp or Lc. The recommended setting value is described in
the Operation Manual.
NOTE The contact failure at Lp can not be detected at the range of 220 uF to 1 mF at 120 Hz and
22 uF to 100 uF at 1 kHz. At the same range, the threshold1 is used instead of this for Lc.
(Therefore, the threshold2 is not used at the range).
Parameters
Description
Range
Initial value
Resolution
Query response <numeric><newline><^END>
Related commands [:SENSe][:FIMPedance]:CONTact1:VERify[:STATe] on page 256
[:SENSe][:FIMPedance]:CONTact1:VERify:THReshold1 on page 257
Equivalent key [
Meas Setup
sequence
258
Threshold2 value for contact 1
0 to 1
1
0.01
] - CONT CHK- CC1 TH2
<numeric>
Chapter 10