Calculate1:Format; Calculate1:Math:expression:catalog - Keysight Technologies E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:CALCulate1:FORMat

Syntax :CALCulate1:FORMat {CP|CS}
:CALCulate1:FORMat?
Description Specifies the primary parameter to be measured.
When the secondary parameter has been set to G or RP and the primary parameter is set to
CS, the secondary parameter is automatically changed to D. Also, when the secondary
parameter has been set to RS and the primary parameter is set to CP, the secondary
parameter is automatically changed to D.
Parameters
CP (initial value)
CS
Query response {CP|CS}<newline><^END>
:CALCulate2:FORMat on page 191
Related commands
Equivalent key [
Meas Setup
sequence

:CALCulate1:MATH:EXPRession:CATalog?

Syntax :CALCulate1:MATH:EXPRession:CATalog?
Description Reads out available parameters used when executing the command to specify the
expression of the primary parameter in the deviation measurement mode (the
(:CALCulate1:MATH:EXPRession:NAME
DEV,PCNT. (Query only)
Query response {DEV,PCNT}<newline><^END> (fixed)
Related commands :CALCulate1:MATH:EXPRession:NAME on page 189
Equivalent key No equivalent key is available on the front panel.
sequence
188
Specifies the capacitance value measured using the parallel
equivalent circuit model for the primary parameter.
Specifies the capacitance value measured using the series
equivalent circuit model for the primary parameter.
]- FUNC
Description
command). The query response is always
Chapter 10